cameroon gce intermediate level 2025 building construction drawing 1
cameroon gce intermediate level 2025 building construction drawing 1
- State the direction in which the Plan of a formwork drawing is viewed
A From Top
B From under
C From side
D Im above the floor
- What is the name of the part denoted ‘a’ as Seen in figure 7
Figure 7
a Table
b Television
c Wardrobe
d Chimney
- Select an isometric projection from the sketches in figure 8
Figure 8
A a
B c
C b
D d
- Select the left side elevation from the given views In figure 9
Figure 9
A c
B d
C a
D b
- A plan that shows the various components in a building is:
A Plumbing plan
B Distribution plan
C Architectural plan
D Foundation plan
- Select the Front view from the given views as shown in figure 10
Figure 10
A b
B d
C a
D c
- Choose the front elevation from the given views In figure 11
Figure 11
A b
B d
C a
D c
- Where are wardrobes usually located in buildings
A Parlour
B Dinning
C Bedroom
D Corridor
- Select the Top view from the given views in figure 12
Figure 12
A b
B c
C d
D a
- Calculate the dimension of a piece of land measuring (20×25)m to a scale of 1:50
A (0.4×0.5)m
B (40×50)m
C (4×5)m
D (20×25)m
- Which of the sections below represent section A-A as seen in figure 1
Figure 1
A b
B c
C d
D a
- State the purpose of cross sectional views in Technical Drawing
A Show various elements and lines
B Show the areas of floors
C Show various thickness and height
D Show all elements
- Select a view which represents the Left end view as seen in figure 2
Figure 2
A c
B b
C d
D a
- Name the element denoted C2 as seen in figure 3
Figure 3
A Gusseted Cantilever
B Gusseted Beam
C Projected Beam
D Projected Slab
- State the use of a scale rule
A Measuring distances on drawing
B Drawing lines to scale
C Convert angles to scale
D Convert distances to scale
- Identify the Plan view from the sketches in figure 4
Figure 4
A a
B b
C d
D c
- Calculate the difference in level between floor F1 and R from the various floor levels as indicated in figure 5
Figure 5
A 13.50m
B 6.50m
C 10.00m
D 3.50m
- Overhead Rolling doors are best use as
A Main doors
B Gate doors
C Warehouse doors
D Exit doors
- Choose the layout which correspond to the placement of views in third angle projection from the sketches figure 6
Figure 6
A a
B b
C d
D a
