Ordinary level 2026 North West mock Engineering drawing 2

Ordinary level 2026 North West mock Engineering drawing 2

Ordinary level 2026 North West mock Engineering drawing 2

Here are the questions and instructions extracted from the second image:

WORK TO BE DONE

PART I – TECHNOLOGICAL STUDY (20 marks)

Question 1: Functional analysis and designation of pieces (5 marks)

  • 1-1 Give the role of the flat on the big diameter of piece 3. (Removed section D-D).

  • 1-2 Give the role of the two opposite flats on the smooth area of piece 7. (see the removed section C-C)

  • 1-3 Designation of pieces

    • Body 1 is fixed on the casing with the piece designated Screw CHC M8 -15. Interpret each element of this designation.

Question 2: Knowledge on materials (5 marks)

  • 2-1 Decode the designation 35 Ni Cr 6 of the material of piece 7 by indicating the significance of each element in this designation.

  • 2-2 Indicate the name of the family of materials in which piece 10 belongs by marking an X beside the right answer.

Question 3: Study of linkages (5 marks)

  • Indicate the nature, mode and three (03) characteristics of each of the links 1-7 and 3-1 (by completing or by encircling the right answers on the table).

Question 4: Fit (5 marks)

  • Given:

    • the fit between 1 and 2 is: $\phi 12\ H7\ m6$;

    • the fit between 1 and 3 is: $\phi 29\ H7\ g6$.

  • 4-1 Calculate the maximum and minimum clearances of the fit between 1 and 2.

  • 4-2 Hence deduce the nature (the type) of fit.

Question 5: Chain of dimensions (5 marks)

  • 5-1 Draw the minimal chain of dimensions related to the condition dimension $\vec{a}$

  • 5-2 Give the equations of the maximum and minimum allowances of $\vec{a}$


PART II – GRAPHIC STUDY (30 marks)

On an A4 V tracing paper, with instruments and pencil, complete to scale 3:2 on page 6/6, the detail drawing of body 1 in the following views:

  • Front view section A-A;

  • ½ top view (do not draw the hidden contours)

  • Indicate the functional dimensions of all the threaded holes and the fit dimensions on the drawing.

PDF is loading please wait...

 

One comment on “Ordinary level 2026 North West mock Engineering drawing 2”

Leave a comment

Your email address will not be published. Required fields are marked *

sponsors Ads