cameroon gce intermediate level manufacturing processes 1
cameroon gce intermediate level manufacturing processes 1
1. Which of the following is incorrect about precautions
in using a micrometer?
A | Final movement is given by ratchet |
B | Thimble is turned till the Measuring tip just touches the part to be measured |
C | Part to be measured is held in right hand and micrometer in left hand for good results |
D | Error is reading is may be due to lack of flatness of anvil |
_____________________________________________
2. Which of the following is not a name of slip gauges?
A | Gauge Blocks |
B | Johannsen Gauges |
C | Gage Blocks |
D | Linear Gauges |
_____________________________________________
3. Grooving is an operation of.
A | Beveling the extreme end of a workpiece |
B | Reducing the diameter of a workpiece over a very narrow surface |
C | Embossing a diamond shaped pattern on the surface of a workpiece |
D | Enlarging the end of a hole cylindrically |
_____________________________________________
4. In reaming process
A | Metal removal rate is high |
B | High surface finish is obtained |
C | High form accuracy is obtained |
D | High dimensional accuracy is obtained |
_____________________________________________
5. Why tolerances are given to the parts?
A | Because it’s impossible to make perfect settings |
B | To reduce weight of the component |
C | To reduce cost of the assembly |
D | To reduce amount of material used |